Remove/install belt pulley - AR03.30-P-1700MCU
ENGINE 132.910 in MODEL 451.3/4
| Remove/install | |||
| 1 | Remove poly-V belt | AR13.22-P-1202MCU | |
| 2 | Remove poly-V belt for supercharger | On vehicles with code (I01) Air conditioning Plus | AR13.21-P-1202MCU |
| 3 | Remove starter | AR15.30-P-7100MCU | |
| 4 | Attach retaining lock for engine | AR03.30-P-1600-06MCE | |
| Fig 2 | |||
| 5 | Remove bolt (2) and take off together with disc (3) | *BA03.30-P-1001-01P | |
| 6 | Detach crankshaft belt pulley (1) to crankshaft and take off | Check contact surface of the crankshaft radial sealing ring on the crankshaft belt pulley (1); replace crankshaft radial sealing ring if necessary. Refer to: ↓ Replace front crankshaft radial sealing ring |
AR03.20-P-3000MCU |
| 7 | Install in the reverse order |
FLYWHEEL, DRIVEN PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | ENGINE 132.9 | ||
|---|---|---|---|---|
| BA03.30-P-1001-01P | Belt pulley/vibration damper to crankshaft | Stage 1 | Nm | 150 |
| Stage 2 loosen | Nm | ≥ 150 | ||
| Stage 3 | Nm | 50 | ||
| Stage 4 | ∠° | 60 | ||