Inspection Procedure
- CONFIRM DTC OUTPUT (CAN COMMUNICATION DTC)
- Check DTC (See DTC CHECK / CLEAR
).
Result
RESULT CHARTResult Proceed to DTC U0129 is not output A DTC U0129 is output B
B: Go TO DIAGNOSTIC TROUBLE CODE CHART .
A: Go to next step
- Check DTC (See DTC CHECK / CLEAR
).
- CONFIRM DTC OUTPUT (SPEED SENSOR DTC)
- Check DTCs (See DTC CHECK / CLEAR
).
Result
RESULT CHARTResult Proceed to DTC C0200/31, C0205/32, C0210/33 and/or C0215/34 is not output A DTC C0200/31, C0205/32, C0210/33 and/or C0215/34 is output B
B: Go TO DIAGNOSTIC TROUBLE CODE CHART
A: Go to next step
- Check DTCs (See DTC CHECK / CLEAR
).
- PERFORM ACTIVE TEST USING TECHSTREAM (SPEED METER)
- Connect Techstream to the DLC3.
- Turn the ignition switch on (IG) and turn the tester ON.
- Operate the Techstream according to the display and select "ACTIVE TEST" (See DATA LIST / ACTIVE TEST
).
Body Electrical / Combination meter / Active Test:
BODY ELECTRICAL / COMBINATION METER / ACTIVE TESTItem Test Details Diagnostic Note Speed Meter Operation 0 / 24 (40) / 48 (80) / 72 (120) / 96 (160) /120 (200) mph (km/h) Value selected during Active Test is displayed OK:
Vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.
NG : REPLACE COMBINATION METER ASSEMBLY (See REMOVAL )
OK: Go to next step
- READ VALUE USING TECHSTREAM (SPEED METER)
- Connect Techstream to the DLC3.
- Turn the ignition switch on (IG) and the tester on.
- Operate the Techstream according to the display and select "DATA LIST" (See DATA LIST / ACTIVE TEST
).
Body Electrical / Combination meter / Data List:
BODY ELECTRICAL / COMBINATION METER / DATA LISTItem Measurement Item / Range Normal Condition Diagnostic Note Vehicle Speed Meter Vehicle speed
Min.: 0 (0)
ax.: 158 (255)Approximately same as actual vehicle speed (When driving) Unit: mph (km/h) OK:
Vehicle speed displayed on the tester is approximately the same as the actual vehicle speed
NOTE: Determine whether the value displayed on the tester is within the acceptable range by referring to reference values described in "ON-VEHICLE INSPECTION " .
NG: Go to step 5
OK : USE SIMULATION METHOD TO CHECK (See HOW TO PROCEED WITH TROUBLESHOOTING )
- REPLACE COMBINATION METER ASSEMBLY
- Replace the combination meter assembly with a new or a normal one (See REMOVAL
).
OK:
The operation of the speedometer returns to normal.
NG : REPLACE ABS AND TRACTION ACTUATOR (SKID CONTROL ECU) (See REMOVAL )
OK : END
- Replace the combination meter assembly with a new or a normal one (See REMOVAL
).