Brake Actuator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
REMOVE WINDSHIELD WIPER ARM COVER (See REMOVAL )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See REMOVAL )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See REMOVAL )
REMOVE HOOD TO COWL TOP SEAL (See REMOVAL )
REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
REMOVE COWL TOP VENTILATOR LOUVER LH (See REMOVAL )
REMOVE FRONT WIPER MOTOR AND LINK (See REMOVAL )
REMOVE OUTER COWL TOP PANEL (See REMOVAL )
REMOVE AIR CLEANER ASSEMBLY (See REMOVAL )
REMOVE BRAKE ACTUATOR ASSEMBLY
1. Release the lock lever and disconnect the brake actuator connector.
  NOTE: Be careful not to allow brake fluid to enter the removed connector.
  
  Fig 1: Disconnecting Brake Actuator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a union nut wrench, separate the 6 brake tubes from the brake actuator.
  
  Fig 2: Locating Brake Tubes From Brake Actuator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Use tags or labels to identify the place to reconnect each brake tube.
  HINT:
  - *1: To front wheel cylinder RH
  - *2: To front wheel cylinder LH
  - *3: To rear wheel cylinder RH
  - *4: To rear wheel cylinder LH
  - *5: From 1st master cylinder
  - *6: From 2nd master cylinder
    
    Fig 3: Identifying Brake Tube
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the 2 tube clamps from the actuator bracket.
5. Remove the 3 nuts and brake actuator with bracket.
  NOTE: Do not damage the brake tubes or wire harness.
  
  Fig 4: Locating Nuts And Brake Actuator With Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY
1. Remove the 4 bolts and actuator bracket.
  
  Fig 5: Identifying Bolts And Actuator Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002