Rear Center Seat Outer Belt Assembly: Installation

CAUTION: Always use "TORX" socket wrench E10 when installing the rear seat.

INSTALL SEAT BELT ANCHOR COVER
1. Install the rear seat shoulder belt cover.
  
  Fig 1: Identifying Rear Seat Shoulder Belt Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHOULDER BELT ANCHOR COVER RH
1. Engage the 4 claws and install the seat belt anchor cover.
  
  Fig 2: Identifying Seat Belt Anchor Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY
1. Check the angle of inclination required to lock the retractor.
  1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
    NOTE: Do not disassemble the retractor. If the operation is not as specified, replace the rear seat outer belt.
    
    Fig 3: Identifying Rear Seat Outer Belt Lock And Unlock Position
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Hook the lower stay of the retractor onto the 2 body hooks and install the retractor with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 4: Locating Hooks And Retractor With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Insert the hook into the body hole and install the bracket with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 5: Locating Hook And Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Check that the ELR locks.
  NOTE: Perform the check with the rear center seat outer belt installed.
  1. With the belt installed, check that the belt locks when it is pulled out quickly.
    If the operation is not as specified, replace the rear center seat outer belt.
5. Install the through anchor with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 6: Locating Anchor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Engage the 2 claws and close the slip joint cover.
INSTALL ROOF SIDE INNER GARNISH RH (See INSTALLATION )
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (See INSTALLATION )
INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (See INSTALLATION )
INSTALL REAR SEAT OUTER BELT ASSEMBLY RH (See INSTALLATION )
INSTALL REAR DECK TRIM COVER (See INSTALLATION )
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE RH (See INSTALLATION )
INSTALL REAR SEAT ASSEMBLY RH (See INSTALLATION )
INSTALL NO. 1 REAR SEAT LEG COVER (See INSTALLATION )
INSTALL DECK BOARD SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)