LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.4L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    CAUTION: Refer to Fastener Caution .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 2: Identifying EVAP Canister Purge Solenoid Valve Tube
    GM1571757Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve tube. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: Identifying EVAP Canister Purge Valve Electrical Connector & Engine Harness Clips
    GM1591661Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister purge valve electrical connector (1).
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (SKY) or Air Inlet Grille Panel Replacement (Solstice) .
scientia non olet · About LEMON Manuals