Hazard Lamps Always On

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views
1	Did you perform the Lighting System Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Turn ON the ignition, with the engine OFF. Place the hazard switch to the OFF position. Are the hazard lamps off?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Repair an short to ground in the turn/hazard request circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the repair?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2