Circuit/System Verification
- Command the park lamps ON and OFF using the headlamp switch. Verify the scan tool Park Lamp Switch parameter cycles between Active and Inactive as commanded.
- If the parameter does not cycle between the specified values, refer to PARK LAMP SWITCH MALFUNCTION .
- Ignition ON, switch ON and OFF the park lamps and number plate lights by using the headlamp switch. Park lamps and number plate lights should go ON and OFF.
- If the park lamps are inoperative, refer to PARK LAMPS INOPERATIVE .
- If the number plate lights are inoperative, refer to LICENSE PLATE LIGHTS INOPERATIVE .