Subsequent Work

1. Install pneumatic spring.

   > 61321931 Removing and installing pneumatic spring - section on  "INSTALLING "

2. Install front roof frame.

   > INSTALLING FRONT ROOF FRAME  - section on "Installing"

3. Tighten front convertible top support to the specified tightening torque. > Anziehdreh moment 46 N.m (34 ft lb.)  Tighten rear convertible top support to the specified tightening torque. > Tightening torque 46 N.m (34 ft lb.) 
4. Adjust lid support bearing.

   > ADJUSTING REAR LID

5. Install convertible top covering with roof struts.

   > INSTALLING CONVERTIBLE TOP COVERING  - section on "Installing"

6. Check that the convertible top is working correctly.

Fasten rivets using > VAS 5072A - Pop Rivet Pliers  .