Removing wire harness for front-end

Information 

• Some of the repair illustrations show only one side of the vehicle or a similar component  .
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Switch off ignition and pull remote control out of ignition lock.
2. Release electric plug connection -1-  at the microswitch for the front lid lock at the left and right and disconnect it. → 558519 REMOVING AND INSTALLING MICROSWITCH FOR FRONT LID LOCK
3. Release electric plug connection -2-  at the garage door opener control unit and disconnect it. → 967919 REMOVING AND INSTALLING GARAGE DOOR OPENER CONTROL UNIT
4. Release electric plug connection -3-  at the horn at the left and right and disconnect it. → 905019 REMOVING AND INSTALLING HORN
5. Release electric plug connection -4-  at the outside-temperature sensor and disconnect it. → 916819 REMOVING AND INSTALLING OUTSIDE-TEMPERATURE SENSOR

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

6. Release electric plug connection -1-  at the air-conditioning pressure switch and disconnect it. → 878319 REMOVING AND INSTALLING PRESSURE SWITCH

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

7. Release electric plug connections -1-  under the left headlight and disconnect them.
8. Unclip plug connection -2-  for antenna line from the holder and release and disconnect it.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

9. Unclip all holders -1-  for the front-end wire harness -2-  and remove front-end wire harness.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.