Re-programming instrument cluster
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Re-program
the instrument cluster
using the PIWIS Tester with test software version 16.000 (or higher) installed:
- 1.1. Carry out general preliminary work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "PRELIMINARY WORK"
- 1.2. The basic procedure for control unit programming is described in the: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER
.
Specific information on control unit programming during this repair measure:
Required PIWIS Tester software version: 16.000 (or higher) Type of control unit programming: Control unit programming is performed using the 'Campaign' function in the Additional menu on the PIWIS Tester by entering a programming code. Programming code: C4P5R Data record programmed during this campaign: 0563
When programming is complete, the data record can be read out of the instrument cluster in the → 'Extended identifications' menu using the PIWIS Tester.Programming sequence: Read and follow the information and instructions on the PIWIS Tester during the guided programming sequence.
Do not interrupt programming and coding .Procedure in the event of error messages appearing during the programming sequence: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "FAULT FINDING" . Procedure in the event of abnormal termination of control unit programming: Repeat control unit programming by entering the programming code again. - 1.3. Carry out general subsequent work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "SUBSEQUENT WORK"