LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 742 (9X - Electrical System - General) >> WM 9X00IN Basic instructions and procedure for control unit programming using the PIWIS Tester >> General preliminary work

General preliminary work

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect a battery charger with a current rating of at least 40 A  (e.g. Battery Charger, 90 A WE 1391  ) to the jump-start terminals in the engine compartment and switch it on.
  2. Switch on the ignition using the original driver's key  .

    On vehicles with "Porsche Entry & Drive", do this by replacing the control panel in the ignition lock with the original driver's key if necessary.

  3. PIWIS Tester II 9818  must be connected to the vehicle communication module (VCI) via the USB cable  . Then, connect the communication module to the vehicle and switch on the PIWIS Tester.
scientia non olet · About LEMON Manuals