LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (10 - Engine - Crankcase, Suspension (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 100119 Removing And Installing Engine >> Preliminary Work >> Preliminary Work For Removing And Installing Engine

Preliminary Work For Removing And Installing Engine

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Read out the DME fault memory.

    > WM 0101IN DIAGNOSTIC SYSTEM: PERFORMING VEHICLE HANDOVER (CAYENNE, CAYENNE (3.0), CAYENNE GTS, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO & CAYENNE TURBO S : Reading out fault memory and activating systems

  2. For vehicles with air suspension:

    Move air suspension into service position.

    > WM, 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM .

  3. Remove engine guard with transverse strut.

    > 108019 Removing and installing engine guard -  "REMOVING "

  4. On vehicles with 19-inch brake system: Remove the air guide at the anti-roll bar.

    >WM 407719 REMOVING AND INSTALLING ANTI-ROLL BAR (EXCEPT CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0)) "Removing"

  5. Disconnect the battery.

    > 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY

  6. Remove front wheels.

    > 440519 Removing and installing wheel -  "REMOVING "

  7. Remove the front wheel housing liners.

    >WM 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER "Removing"

  8. Move bonnet into service position.

    > WM 553119 REMOVING AND INSTALLING FRONT PNEUMATIC SPRING (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0)) "Removing"

  9. Remove right cross panel.

    >WM 508119 REMOVING AND INSTALLING CROSS PANEL "Removing"

  10. Remove engine compartment trim panels.

    >WM 700219 REMOVING AND INSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0)) "Removing"

  11. Loosen the torque support.

    > 103719 Removing and installing torque support -  "REMOVING "

  12. Remove design cover on throttle valve.

    > 108319 Removing and installing engine cover (design cover) -  "REMOVING "

  13. Drain coolant.

    > 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING)

  14. Evacuate the air conditioning system.

    >WM 870317 DRAINING AND FILLING REFRIGERANT (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))