LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (15 - Engine - Cylinder Head, Valve Control) >> WM 153519 Removing And Installing Timing Chains On V6 DFI Engines (Cayenne Tip, Cayenne Man) >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove all engine compartment covers. → Removing front trim (engine compartment)
  2. Remove engine. → Removing engine
  3. Remove transmission.
    1. 3.1. For vehicles with manual transmission, see: → Removing transmission
    2. 3.1.1. Remove flywheel. → Removing flywheel (dual-mass flywheel)
    3. 3.2. For vehicles with automatic transmission, see: → Removing transmission
    4. 3.2.1. Remove drive plate for torque converter. → Removing drive plate for torque converter on DFI engines
  4. Remove intake-air distributor. → Removing intake-air distributor
  5. Remove cylinder head cover. → Removing cylinder head cover 
  6. Remove the timing-case cover at the top and bottom. → Removing timing-case cover 
  7. Set crankshaft to compression TDC for cylinder 1 → Checking the timing 
    Fig 1: Locating TDC Marking On Cylinder 1
    G09409203Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals