LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (17 - Engine - Lubrication) >> WM 172019 Removing And Installing Oil Pump On V6 DFI Engines (Cayenne Tip, Cayenne Man) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install timing chains. → Installing Timing Chains
  2. After you have fitted the timing chains, turn the crankshaft twice and check the timing. → WM 150502 CHECKING THE TIMING ON V6 DFI ENGINES
  3. Fit the timing-case cover at the top and bottom. → Installing Upper Timing-Case Cover
  4. Install the cylinder head cover. → Installing Cylinder Head Cover
  5. Install intake-air distributor. → Installing intake-air distributor
  6. Install transmission.
    1. 6.1. For vehicles with manual transmission, see: → Installing Transmission
    2. 6.1.1. Install flywheel. → Installing flywheel (dual-mass flywheel)
    3. 6.2. For vehicles with automatic transmission, see: → Installing Transmission
    4. 6.2.1. Remove drive plate for torque converter. → Installing drive plate for torque converter on DFI engines
  7. Install engine. → Installing drive plate for torque converter on DFI engines
  8. Install all engine compartment covers. → Installing front trim (engine compartment)
scientia non olet · About LEMON Manuals