Subsequent Work
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Check connection points on main wire harness for corrosion and rework if necessary. → Reworking Main Wire Harness
- Install alarm siren. → Installing The Alarm Siren
- Install DME control module. → Installing Dme Control Unit
- Install wiper motor. → Installing Wiper Motor
- Install primary catalytic converter. → Installing Primary Catalytic Converter
- Install cardan shaft. → Installing Front Cardan Shaft
- Lower the vehicle. → WM 4000V0 LIFTING THE VEHICLE (ALL MODELS)
- Carry out work instructions after disconnecting the battery. → 2706IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY