LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (92 - Windshield Wiper And Washer System) >> WM 921519 Removing And Installing Wiper Motor (All Models) >> Installing Wiper Motor

Installing Wiper Motor

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before attaching wiper motor to wiper linkage, connect wiper motor to electrical plug connection, close bonnet, operate one-touch wipe at least once and let motor run to the end position. Disconnect plug connection again.
  2. Before attaching wiper arms, the wiper motor must be operated a second time at least once with one-touch wipe and run to the end position. Close bonnet.

    Information 

    • If a new wiper motor is being installed, ensure that the correct Porsche original screws are used. 
  3. Fit wiper motor to wiper linkage and position it. Screw in fastening screws -10-  and tighten to the specified tightening torque. → Tightening torque: 6.5 ftlb. 
    Fig 1: Installing Fastening Parts For Wiper Linkage
    G09415177Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Place linkage on wiper shaft, position it, set dimension -X-  = 4 mm between mechanical stop and motor crank (wiper motor) and tighten with fastening nut -9-  . → Tightening torque: 13 ftlb. 
    Fig 2: Dimension Between Mechanical Stop And Motor Crank
    G09415178Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Position wiper system. Engage support -B-  on the body, insert wiper motor with linkage downwards on the driver's side, rotate wiper linkage slightly and lay it down.
    Fig 3: Installing Wiper Motor With Linkage
    G09415179Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    Observe the order for the fastening screws.

  6. Position fastening screws -8-  for wiper system and tighten beginning on the driver's side. → Tightening torque: 7.5 ftlb. 
    Fig 4: Fitting Fastening Screws For Wiper Linkage
    G09415180Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Connect electrical plug connection -A-  .
    Fig 5: Connecting Plug Connection For Wiper Motor And Tightening Front Fastening Screws
    G09415181Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  8. Tighten front fastening screws for wiper system -7-  . → Tightening torque: 6.5 ftlb. 
scientia non olet · About LEMON Manuals