LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (15 - Engine - Cylinder Head, Valve Control -- 987-BOXSTER-CAYMAN) >> WM 157019 Removing And Installing Cylinder Head (All Models) >> Preliminary Work >> Preliminary Work For Cylinder Head 4-6

Preliminary Work For Cylinder Head 4-6

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine.

    → Removing Engine .

  2. Completely remove intake-air distributor.

    → Removal .

  3. Remove hydraulic return line for power steering from the oil/water heat exchanger and pull it out of the holder.
  4. Pull off positive crankcase ventilation line.
  5. Remove positive crankcase ventilation cover on the cylinder head.
    1. Positive crankcase ventilation cover
    2. O-ring, always replace
    3. External Torx screw, M6
      Fig 1: Identifying Positive Crankcase Ventilation Cover
      G09585627Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Remove vacuum pump.

    → Removing Vacuum Pump .

  7. Remove cylinder head cover.

    → Removing Cylinder Head Cover  .

  8. Remove camshafts.

    → Removing Camshafts  .

scientia non olet · About LEMON Manuals