Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Additional work for all-wheel drive vehicles:

Install cardan shaft.
→ Installing Cardan Shaft .
Install cover for centre underbody.
→ Installing Cover For Centre Underbody .

All vehicles:
Install tailpipe cover.
→ Installing Tailpipe Cover .

Information

The Porsche Doppelkupplung (PDK) control unit only has to be calibrated using PIWIS Tester II 9818 if a new transmission was installed.
Calibrate the Porsche Doppelkupplung (PDK) control unit and erase the fault memory.
PIWIS Tester II 9818 .
Check ATF and oil for final drive and top up if necessary.
→ 370235 CHECKING AND TOPPING UP ATF (CLUTCH FLUID) .

→ 399035 CHECKING AND TOPPING UP OIL FOR FINAL DRIVE (WITH TRANSMISSION OIL) .
Carry out a function test on the parking lock.
→ Installing Locking Cable .
Install rear underbody panelling.
→ 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .
Connect the battery.
→ 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
Bleed the PDCC system.
→ 430307 BLEEDING THE PDCC SYSTEM .
Check engine coolant level and fill to maximum level if necessary.