LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (34 Mechanical Transmission Actuator Housing -- 911 CARRERA (991)) >> WM 343519 Removing And Installing Transmission (Except CARRERA "Edition", CARRERA Cabriolet "Edition", Turbo, Turbo S, CARRERA 4 "Edition", Turbo CABRIO, Turbo S CABRIO, CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Check transmission oil and top up if necessary.

    → Topping Up Transmission Oil  .

  2. Carry out a function test on the shift and selector cables.

    → Removing Shift And Selector Cables .

  3. Fit rear underbody panelling.

    → INSTALLING COVER FOR REAR UNDERBODY .

    Additional work for all-wheel drive vehicles: 

  4. Install cardan shaft.

    → INSTALLING CARDAN SHAFT .

  5. Install cover for center underbody.

    → INSTALLING COVER FOR CENTRE UNDERBODY .

    All vehicles: 

  6. Check the coolant level and top up if necessary.

    → 193817 DRAINING AND FILLING COOLANT .

  7. Bleed the cooling system.

    → 190107 BLEEDING THE COOLING SYSTEM .

  8. Connect the battery.

    → 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .

scientia non olet · About LEMON Manuals