Removing frame for sliding roof cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Frame For Sliding Roof Cover - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

SLIDING ROOF COVER FRAME REMOVING PROCEDURE - TARGA

No.	Procedure	Instructions
	Removing the front fabric lining	See Removing the front fabric lining .
	Removing cover for sliding roof	See Removing and installing cover for sliding roof - Targa .
	Requirement for removing the frame for the sliding roof cover	To remove the frame of the cover for the sliding roof, the mounts must be moved into horizontal position. - By actuating the rocker switch. or - See Sliding roof emergency operation mechanism .
1	Unscrewing fastening screws	Unscrew the fastening screws -1-2 and 3- . See Fig 1.
2	Cutting tie-wrap	Cut through the tie-wrap -arrow- . See Fig 1.
3	Removing the frame for the sliding roof cover from the roof module frame	Raise the frame for the sliding roof cover -4-5- . See Fig 1.