Adjusting rear lid in X and Z direction

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Adjusting Rear Lid

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Set gap dimensions on lid and accessories in accordance with the gap specifications.
Given a clearance in the opening that is too great or too small, the accessories must be centred with respect to the body.
Ensure that the gaps do not run in a wedge-shaped fashion or do not narrow at local points.
The given values are guidelines, which should be observed as far as possible.
The guidelines apply to repair and assembly work.
Use star gauges to check the gap dimensions. Star gauges for body gap dimensions NR.127-1

Check gap dimensions of rear lid. → 5000IN DIAGRAM - BODY GAP DIMENSIONS
Undo fastening screw -1- on both sides of the rear lid -2- .

Fig 2: Adjusting Rear Lid In X And Z Direction
Courtesy of PORSCHE CARS NORTH AMERICA, INC.