Diagram Of Body Bonding Points And Sealing Elements
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- A - Bonding area for cowl panel frame, roof frame → 510355 REPLACING ROOF FRAME
- B - Bonding area for window slot reinforcement → 536155 REPLACING INNER SIDE SECTION
- C - Bonding area for side section → 536155 REPLACING INNER SIDE SECTION
- D - Expanded sealant in rear side member. If the side member is replaced during repairs, the side member is sealed with a 2K acoustic filling foam. → 534855 REPLACING REAR SIDE MEMBER
- E - Spot welding/bonding method in area of wheel housing, inner side section and outer side section. → 535555 REPLACING SIDE SECTION
- F - Bonding area for light housing → 535555 REPLACING SIDE SECTION
- G - Seal (molded part) in area of inner side section and outer side section. → 535555 REPLACING SIDE SECTION
- H - Expanded sealant riveted to rear center panel.
- I - Spot welding/bonding method in area of inner side member → 536155 REPLACING INNER SIDE SECTION
- I - Spot welding/bonding method in area of inner A-pillar and cowl panel frame → 513755 REPLACING OUTER HINGE PILLAR
- J - Spot welding/bonding method in area of lateral reinforcement → 531755 SIDE REINFORCEMENT
The bonding and sealing elements must be replaced during repairs. The procedure is described in the relevant chapter on body repairs.