Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Hot components

Risk of burns

→ Let hot components cool down.

→ Wear personal protective gear.

Remove engine.
→ 100119 REMOVING AND INSTALLING ENGINE .
Remove rear silencer.
→ 263319 REMOVING AND INSTALLING REAR SILENCER - TURBO .
Remove turbocharger.
→ 213019 REMOVING AND INSTALLING TURBOCHARGER .
Remove turbocharger holder.
1. 4.1. Unscrew two Torx screws (M8 x 35) and remove the holder.
Remove heat shield for ignition coils.
→ 261219 REMOVING AND INSTALLING HEAT SHIELD - TURBO .
Remove ignition coils. In each case, unscrew one internal Torx (T30) countersunk screw (M6 x 16) and pull ignition coils out of the spark-plug recess.
→ 282019 REMOVING AND INSTALLING IGNITION ROD MODULE .