Subsequent Work For Bearing Cover For Intermediate Shaft

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Tiptronic Transmission:

Install drive plate for converter → WM 136319 REMOVING AND INSTALLING DRIVE PLATE FOR CONVERTER - section on "Installing".
Refit Tiptronic transmission → WM 373527 REMOVING AND MOUNTING AUTOMATIC TRANSMISSION - section on "Mounting".
Install engine → REMOVING AND INSTALLING ENGINE (VEHICLE WITH TIPTRONIC TRANSMISSION) - section on "Installing".

Manual Transmission:

Install double-mass flywheel → WM 136019 REMOVING AND INSTALLING DUAL-MASS FLYWHEEL - section on "Installing".
Install clutch → WM 305019 REMOVING AND INSTALLING CLUTCH - section on "Installing".
Install transmission → WM 343519 REMOVING AND INSTALLING TRANSMISSION - section on "Installing".
Filling in engine oil → WM 170155 CHANGING ENGINE OIL AND OIL FILTER - section on "Filling in".
Install air cleaner housing → WM 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - section on "Installing".
Information
- Note the work instructions for disconnecting and reconnecting the battery.
Connect the battery → WM 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY (CARR. COUPE, CARR. S COUPE, "SPORT CLASSIC", CARR. CABRIO, CARR. S CABRIO, CARR. 4 COUPE, TURBO COUPE, CARR. 4S COUPE, TARGA 4, TARGA 4S, CARR. 4 CABRIO, CARR. 4S CABRIO, GT3, GT2, GT3 RS)