LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (87 - Air Conditioning -- CARRERA (997)) >> WM 873419 Removing And Installing Air-Conditioning Compressor (911 Turbo Coupe, 911 Turbo S Coupe, 911 Turbo S Coupe "Ed. 918 SPYDER", 911 Turbo CABRIO, 911 Turbo S CABRIO, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 Gt2) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install throttle housing. → INSTALLING THROTTLE HOUSING
  2. Fit drive belt. → INSTALLATION
  3. Fit pressure pipe. → INSTALLING PRESSURE PIPE 
  4. Install air cleaner housing.→ INSTALLING AIR CLEANER HOUSING
  5. Fill refrigerant on the air-conditioning system in accordance with regulations. → Draining And Filling In Refrigerant  
  6. Open air outlet nozzles on the dashboard, and set fan to at least 75 %.
  7. After allowing the system to stabilize at idle speed (approx. 5 sec.), switch on air conditioner and allow the engine to run uninterrupted for at least 2 minutes at 1500 RPM.
  8. Switch off the air conditioner again. Do not drive until the air conditioner has been filled.
scientia non olet · About LEMON Manuals