LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (24 - Fuel System - Electronic Ignition -- CARRERA (997)) >> WM 244219 Removing And Installing Throttle Housing (Except Turbo Coupe, Turbo S Coupe, Turbo CABRIO & Turbo S CABRIO) >> Installing Throttle Housing

Installing Throttle Housing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position throttle housing and fit it with four external Torx screws (M6 x 50). When doing so, make sure that the holder is fitted correctly on the rubber mounting.
  2. Tighten M6 collar nut on the throttle housing holder to the prescribed torque.
  3. Tighten fastening screws on the throttle housing to the prescribed torque.
  4. Fit cable plug on the throttle housing and clip cable into the sheetmetal holder.
scientia non olet · About LEMON Manuals