Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of objects or loads falling down

Risk of squashing or crushing

→ Secure components to prevent them from falling down.

Raise the engine into installation position.
1. 1.1. Tighten M12 collar nuts.
  → Tightening torque: 85 Nm (63 ftlb.)
2. 1.2. Engine retainer plate 9111/3 and accessories must be removed.
Install rear silencer.
→ Installing Rear Silencer .
Install the drive belt.
→ 137819 REMOVING AND INSTALLING DRIVE BELT .
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING .