LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (69 Occupant Protection/Personal Protection -- CARRERA (997)) >> WM 697719 Removing And Installing Frame For Roll-Over Protection System (CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARRERA CABRIO Black Edition, CARR. CABRIO "Edition Style", CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure motor for convertible-top compartment lid drive. → 619619 REMOVING AND INSTALLING CONVERTIBLE TOP CONTROL UNIT
  2. Push relay carrier into its retaining frame and engage firmly. → 979009 REMOVING AND INSTALLING RELAY CARRIER
  3. Lock plug connections for convertible-top control unit. → WM 619619 REMOVING AND INSTALLING CONVERTIBLE TOP CONTROL UNIT
  4. Lock plug connections for DME control module. → 247019 REMOVING AND INSTALLING DME CONTROL MODULE
  5. Install hydraulic pump. → Installing Hydraulic Pump
  6. Secure seat belt and rear mounting component at the left and right. → 691219 REMOVING AND INSTALLING REAR THREE-POINT BELT 
  7. Install rear side trim panel at left and right. → Installing Rear Side Trim Panel
  8. Press in roll-over bar and perform a function test on the roll-over protection modules. → 697219 REMOVING AND INSTALLING ROLL-OVER BAR 
  9. Install cover for rear. → 705319 REMOVING AND INSTALLING REAR COVER
  10. Install trim panel for rear wall → 703119 REMOVING AND INSTALLING REAR WALL TRIM PANEL
scientia non olet · About LEMON Manuals