LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (69 Occupant Protection/Personal Protection -- CARRERA (997)) >> WM 697719 Removing And Installing Frame For Roll-Over Protection System (CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARRERA CABRIO Black Edition, CARR. CABRIO "Edition Style", CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Removing rear wall trim panel → 703119 REMOVING AND INSTALLING REAR WALL TRIM PANEL
  2. Remove cover for the rear. → 705319 REMOVING AND INSTALLING REAR COVER
  3. Remove rear side trim panel at left and right. → 707519 REMOVING AND INSTALLING REAR SIDE TRIM PANEL
  4. Undo seat belt and rear mounting component at the left and right. → 691219 REMOVING AND INSTALLING REAR THREE-POINT BELT 
  5. Trigger the roll-over bar. → 697219 REMOVING AND INSTALLING ROLL-OVER BAR 

    Information 

    Do not loosen hydraulic lines at hydraulic pump.

  6. Remove hydraulic pump and set it aside. → 618419 REMOVING AND INSTALLING HYDRAULIC PUMP
  7. Unlock plug connections for DME control module. → 247019 REMOVING AND INSTALLING DME CONTROL MODULE
  8. Unlock plug connections for convertible-top control unit. → 619619 REMOVING AND INSTALLING CONVERTIBLE TOP CONTROL UNIT
  9. Release relay carrier and set it aside. → 979009 REMOVING AND INSTALLING RELAY CARRIER
  10. Remove motor for drive mechanism and set it aside. → 619619 REMOVING AND INSTALLING CONVERTIBLE TOP CONTROL UNIT
scientia non olet · About LEMON Manuals