Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install throttle housing.
→ 244219 REMOVING AND INSTALLING THROTTLE HOUSING - GT2 RS
WARNING: Danger of objects or loads falling down- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
- Raise the engine.
- 2.1. Raise the engine to assembly position using a retainer plate 9592.
- 2.2. Screw in and tighten collar nuts for engine mounting.
→ Tightening torque: 85 Nm (63 ft. lb.)
- Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - GT2 RS .
- Install pressure pipe.
- Connect the battery.
→ 2X00IN02 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .