Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install shut-off valve.
→ 266919 REMOVING AND INSTALLING SHUT-OFF VALVE - section on "Installing" .
Install left intake-air distributor.
→ 244619 00 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR - section on "Installing" .
Remove oil-filter console.
→ 173319 REMOVING AND INSTALLING OIL-FILTER CONSOLE - section on "Installing" .
Install secondary-air pump.
→ 26651900 REMOVING AND INSTALLING SECONDARY-AIR PUMP - section on "Installing".
Raise the engine.
Raise the engine to assembly position using a Retainer Plate 9592 .

Screw in and tighten M12 collar nuts.

→ Tightening torque: 85 Nm (63 ft. lb.)
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - section on "Installing" .
Install pressure pipe.
→ 214119 REMOVING AND INSTALLING PRESSURE PIPE - section on "Installing" .
Install fuel filter.
→ 206019 REMOVING AND INSTALLING FINE FUEL FILTER - section on "Installing" .
Connect the battery.
→ 2X00IN02 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .