Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Caustic fluids
- Danger of chemical burns
→ Avoid contact with caustic fluid.
→ Wear personal protective gear.
→ Ensure that there is good ventilation.
→ If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
- Raise the engine.
Raise the engine into installation position with a jack, using Retainer Plate 9592 to do this.
Screw in and tighten M12 collar nuts.
→ Tightening torque: 85 Nm (63 ft. lb.)
- Fill in coolant and bleed the system.
- Install fuel filter.
- Install air cleaner housing.
- Install pressure pipe.
- Perform a test drive, adjusting the coolant level in the container if necessary (note minimum/maximum marking).