Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install left intake-air distributor.
→ WM 244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR (TURBO) - "Installing" section.
- Raise the engine.
Lift the engine using a jack and Retainer Plate 9592 in the assembly position.
Screw in and tighten M12 collar nuts.
→ Tightening torque: 85 Nm (63 ft. lb.)
- Install fuel filter.
→ 206019 REMOVING AND INSTALLING FINE FUEL STRAINER - "Installing" section
- Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - "Installing" section
- Install pressure pipe.
→ 214119 REMOVING AND INSTALLING PRESSURE PIPE - "Installing" section
- Fill in coolant and bleed the system.
→ 193817 DRAINING AND FILLING COOLANT - "Filling" section