Adjusting the roll-over bar
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
The roll-over bar is measured in production in the vehicle and fixed with dowel pins -6- and dowel sleeves -4- on the left and right sides. See Fig 1 .
The dowel sleeves -4- and dowel pins -6- must not be removed. See Fig 1 .
- Adjustment procedure: Unscrew collar nuts -1- at the screwed points front and rear. See Fig 1 .
- Lift roll-over bar and insert or remove shim plates -2, 3- in Fig 1 according to the test and adjusting values. See TEST AND ADJUSTING VALUES .
- Tighten collar nuts -1- in Fig 1 . See Tightening torques .