Ignition Lock Cylinder Case Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the ignition and start switch. Refer to Ignition and Start Switch Replacement . If equipped with AN3, disconnect the park lock cable. Refer to Transmission Control Replacement . Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement . Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
1	Ignition Lock Cylinder Case Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 7 N.m (62 lb in)
2	Ignition Lock Cylinder Case

Callout

Component Name

Preliminary Procedures

Remove the ignition and start switch. Refer to Ignition and Start Switch Replacement .
If equipped with AN3, disconnect the park lock cable. Refer to Transmission Control Replacement .
Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .

Ignition Lock Cylinder Case Bolt (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
7 N.m (62 lb in)

Ignition Lock Cylinder Case