Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Turn Signal Cancel Cam and Steering Shaft

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
1	Steering Shaft Lock Plate Retaining Ring Procedure Use the J 23653-SIR compressor and the J 42137 adapter to remove the steering shaft lock plate retaining ring. TIP: Do not reuse the steering shaft lock plate retaining ring. Replace it. Special Tools J 23653-SIR Steering Column Lock Plate Compressor J 42137 Cam Orientation Plate Adapter For equivalent regional tools, refer to Special Tools .
2	Steering Shaft Lock Plate TIP: The steering shaft lock plate can only be installed one way, align it to the solitary larger spline on the steering shaft.
3	Turn Signal Cancel Cam TIP: Ensure the turn signal cancel cam is aligned to the turn signal multifunction switch when reinstalling.
4	Steering Shaft Upper Bearing Spring