Ignition Lock Cylinder Case Bracket Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Lock Cylinder Case Bracket & Bolt

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement . Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
1	Ignition Lock Cylinder Case Bracket Bolt CAUTION: Refer to Fastener Caution . TIP: The ignition lock cylinder case bracket bolt is not present on manual steering columns. Tighten 7 N.m (62 lb in)
2	Ignition Lock Cylinder Case Bracket

Callout

Component Name

Preliminary Procedures

Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .

Ignition Lock Cylinder Case Bracket Bolt

CAUTION:

Refer to Fastener Caution .

TIP: The ignition lock cylinder case bracket bolt is not present on manual steering columns.
Tighten
7 N.m (62 lb in)

Ignition Lock Cylinder Case Bracket