LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Interior Trim And Paneling) >> Repair Instructions >> Body Side Trim Panel Replacement - Right Side

Body Side Trim Panel Replacement - Right Side

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Side Trim Panel
GM1959681Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the rear seat number 2, if equipped. Refer to Rear Number 2 Seat Replacement .
  2. Remove the right body lock pillar garnish molding - upper. Refer to Body Lock Pillar Garnish Molding Replacement - Upper (SUV)  or Body Lock Pillar Garnish Molding Replacement - Upper (SUT) .
  3. Remove the liftgate sill panel trim. Refer to Liftgate Sill Trim Plate Replacement .
  4. Remove the right body rear corner upper garnish molding. Refer to Body Rear Corner Upper Garnish Molding Replacement .
1 Body Side Trim Panel Assembly

Procedure

  1. Remove the cap, nut and washer securing the inflator line to the body side trim panel.
  2. Grasp the trim panel and pull outward disengaging the retainer clips securing the trim panel to the body.
  3. Disconnect the electrical connections.
  4. When replacing the body side trim panel, transfer all necessary parts.
2 Retainer Clip (Qty: 10)
scientia non olet · About LEMON Manuals