Low Engine Oil Level Indicator Always On
Low Engine Oil Level Indicator Always On
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: ENGINE CONTROLS CONNECTOR END VIEWS in Engine Controls - 5.3 L, Powertrain Control Module (PCM) Connector End Views in Engine Controls - 3.8 L or to Inline Harness Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Start the engine. Does the LOW OIL LEVEL message display in the driver information center (DIC)? |
- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
| 3 |
|
- | Go to Step 11 | Go to Step 4 |
| 4 |
|
- | Go to Step 6 | Go to Step 5 |
| 5 | Test the signal circuit of the engine oil level switch for the following:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 12 | Go to Step 7 |
| 6 | Test the low reference circuit or the ground circuit of the engine oil level switch for an open or for a high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | Go to Step 8 | |
| 7 | Inspect for poor connections at the harness connector of the ECM/PCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 12 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 12 | Go to Step 10 |
| 9 | Replace the ECM/PCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 12 | - |
| 10 | Replace the engine oil level switch. Refer to Engine Oil Level Sensor and/or Switch Replacement
in Engine Mechanical 5.3 L or Engine Oil Level Sensor and/or Switch Replacement
in Engine Mechanical 3.8 L. Did you complete the replacement? |
- | Go to Step 12 | - |
| 11 | Replace the instrument panel cluster (IPC). Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |