Diagnostic Aids

Use the Freeze Frame and/or Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data may aid in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also aid in determining the number of ignition cycles that the diagnostic reported a pass and/or fail. Operate the vehicle within the same Freeze Frame conditions (RPM, engine load, vehicle speed, temperature, etc.). This will isolate when the DTC failed.
Refer to Testing for Intermittent Conditions and Poor Connections .

DTC P0461

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: ENGINE CONTROLS CONNECTOR END VIEWS in Engine Controls - 5.3 L or to Inline Harness Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Remove the fuel level sender. Inspect for the following items: A stuck fuel level sender (i.e. the fuel strainer interfering with the sender float arm) Foreign material in the fuel tank (ice) Did you find and correct the condition?	Go to Step 4	Go to Step 3
3	Replace the fuel level sender. Refer to Fuel Level Sensor Replacement in Engine Controls - 5.3 L. Did you complete the replacement?	Go to Step 4	-
4	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK