Symptom Table

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the "Self Diagnostic Result" with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom		Probable malfunction location	Inspection item
Front wiper does not operate	HI only	Combination switch (wiper and washer switch) Harness between combination switch (wiper and washer switch) and BCM BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
		IPDM E/R Harness between IPDM E/R and front wiper motor Front wiper motor	Front wiper motor (HI) circuit Refer to Component Function Check .
		Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
	LO and INT	IPDM E/R Harness between IPDM E/R and front wiper motor Front wiper motor	Front wiper motor (LO) circuit Refer to Component Function Check .
	LO only	Combination switch (wiper and washer switch) Harness between combination switch and BCM BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
	LO only	Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
	INT only	Combination switch (wiper and washer switch) Harness between combination switch (wiper and washer switch) and BCM BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
	INT only	Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
	HI, LO and INT	SYMPTOM DIAGNOSIS Refer to Diagnosis Procedure .
Front wiper does not stop	HI only	Combination switch (wiper and washer switch) BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
		Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
		IPDM E/R	-
	LO only	Combination switch (wiper and washer switch) BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
		Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
		IPDM E/R	-
	INT only	Combination switch (wiper and washer switch) BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
	INT only	Front wiper request signal BCM IPDM E/R	IPDM E/R "Data Monitor" "FR WIP REQ"
Front wiper does not operate normally	Intermittent adjustment cannot be performed	Combination switch (wiper and washer switch) Harness between combination switch and BCM BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
	Intermittent adjustment cannot be performed	BCM	-
	Intermittent control linked with vehicle speed cannot be performed	Check the wiper setting is linked with vehicle speed. Refer to CONSULT Function (BCM - WIPER) .
	Wiper is not linked to the washer operation	Combination switch (wiper and washer switch) Harness between combination switch and BCM BCM	Combination switch (wiper and washer switch) Refer to Symptom Table .
	Wiper is not linked to the washer operation	BCM	-
	Does not return to stop position [Repeatedly operates for 10 seconds and then stops for 20 seconds. (Fail-safe)]	IPDM E/R Harness between IPDM E/R and front wiper motor Front wiper motor	Front wiper stop position signal circuit Refer to Component Function Check .