Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

The front wiper does not operate under any operation conditions.

CHECK WIPER RELAY OPERATION

CONSULT

Select "FRONT WIPER" in "Active Test" mode of "IPDM E/R".

While operating the test item, check front wiper operation.

LO	: Front wiper LO operation
HI	: Front wiper HI operation
Off	: Stop the front wiper.

Is front wiper operation normally?

YES

GO TO 4 .

GO TO 2 .

CHECK FRONT WIPER MOTOR FUSE

Check that the following IPDM E/R fuse is not blown:

Component	Location	Fuse No.	Capacity
Front wiper motor	IPDM E/R	41	30A

Is the fuse blown?

YES

GO TO 3 .

Replace the blown fuse after repairing the affected circuit.

CHECK FRONT WIPER MOTOR GROUND CIRCUIT
Check front wiper motor ground circuit. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 4 .

NO

Repair or replace harness.

CHECK FRONT WIPER REQUEST SIGNAL INPUT

CONSULT

Select "FR WIP REQ" in "Data Monitor" mode of "IPDM E/R".
Switch the front wiper switch to HI and LO.

While operating the front wiper switch, check the status of "FR WIP REQ".

Monitor item	Condition		Monitor status
FR WIP REQ	Front wiper switch	HI	Hi
		LO	Low
		INT	1Low
		OFF	Stop

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to Removal and Installation of IPDM E/R .

GO TO 5 .

CHECK COMBINATION SWITCH (WIPER AND WASHER SWITCH)
Perform the inspection of the combination switch (wiper and washer switch). Refer to Symptom Table .

Is combination switch normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

Repair or replace the applicable parts.