LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Rear Differential) >> DTC Troubleshooting Index

DTC Troubleshooting Index

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
DTC(1) SH-AWD Indicator Light Detection Item
12-1  ON Lateral Acceleration Sensor Malfunction
12-2  ON Lateral Acceleration Sensor Malfunction
12-3  ON Lateral Acceleration Sensor Malfunction
15-1  ON Longitudinal Acceleration Sensor Malfunction
16-3  ON Steering Angle Sensor Neutral Position Incorrect
33-2  ON Yaw Rate Sensor Malfunction
33-3  ON Yaw Rate Sensor Malfunction
41-1  ON F-CAN Malfunction (Lost of Communication with Power Control Module (PCM))
41-2  ON F-CAN Malfunction (Lost of Communication with VSA)
41-4  ON F-CAN Malfunction (Lost of Communication with A/T Control Unit)
41-5  ON F-CAN Malfunction (Lost of Communication with Yaw Rate-Lateral Acceleration Sensor)
41-6  ON F-CAN Malfunction (Lost of Communication with Steering Angle Sensor)
42-1  ON Differential Fluid Temperature Sensor (Short to power)
42-2  ON Differential Fluid Temperature Sensor (Open/GND Short)
43-1  ON Differential Fluid Temperature Sensor Circuit Malfunction
44-11  ON SH-AWD Control Unit
44-12  ON SH-AWD Relay Stuck ON
44-32  ON SH-AWD Control Unit Power Supply Stuck ON
44-41  ON SH-AWD Control Unit Power Supply Stuck OFF
44-50  ON SH-AWD Control Unit Power Supply Voltage Low
49-1  ON SH-AWD Control Unit (PG Line Open)
NOTE: The "x" at the end of each DTC denotes a numeric character (0 thru 9) or an alpha character (A thru F) that you will see on the HDS display. The character is unrelated to your troubleshooting; it designates the SH-AWD control unit manufacturer and other details used for product analysis.
(1) DTCs are indicated by the SH-AWD indicator when the data link connector (DLC) is connected to the HDS.
DTC(1) SH-AWD Indicator Light Detection Item
52-3  ON Left Clutch Electromagnetic Coil Current Malfunction
53-1  ON Left Clutch Electromagnetic Coil (Open)
53-2  ON Left Clutch Electromagnetic Coil (Short)
53-3  ON Left Clutch Electromagnetic Coil (Open)
56-3  ON Right Clutch Electromagnetic Coil Current Malfunction
57-1  ON Right Clutch Electromagnetic Coil (Open)
57-2  ON Right Clutch Electromagnetic Coil (Short)
57-3  ON Right Clutch Electromagnetic Coil (Open)
76-1  ON Rear Differential Fluid Overheats
77-1  ON The Functional Abnormalities of Fuel and Emissions
77-2  ON The Functional Abnormalities of VSA Modulator-Control Unit
77-4  ON The Functional Abnormalities of Automatic-Transmission
77-5  ON Yaw Rate-Lateral/Longitudinal Acceleration Sensor Malfunction
77-6  ON Steering Angle Sensor Malfunction
78-XX  ON SH-AWD Control Unit Self-Diagnostic Malfunction
81-1  ON Left Search Coil Sensor Malfunction
82-1  ON Right Search Coil Sensor Malfunction
91-1  ON SH-AWD Control Unit Programming Error
NOTE: The "x" at the end of each DTC denotes a numeric character (0 thru 9) or an alpha character (A thru F) that you will see on the HDS display. The character is unrelated to your troubleshooting; it designates the SH-AWD control unit manufacturer and other details used for product analysis.
(1) DTCs are indicated by the SH-AWD indicator when the data link connector (DLC) is connected to the HDS.