LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Seats) >> Front Seat Ventilation Blower Motor Replacement >> Seat Cushion Blower Motor

Seat Cushion Blower Motor

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

NOTE:
  • Take care not to tear the seams or damage the seat covers.
  • Put on gloves to protect your hands.
  1. Remove the front seat (see FRONT SEAT REMOVAL/INSTALLATION  ).
  2. Disconnect the seat cushion ventilation blower motor duct (see step  5 under Front Seat Cushion Cover Replacement  ).
  3. Disconnect the blower motor connector (A), and detach the clips (B) then remove the blower motor (C) from the seat cushion frame.
    Fig 1: Identifying Blower Motor Connector And Clips
    G08053462Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the blower motor in the reverse order of removal, and note these items.
    • Make sure the blower motor connector is plugged in properly.
    • If the clips are damaged or stress-whitened, replace them with new ones.
scientia non olet · About LEMON Manuals