Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM - COUPE " or "WIRING DIAGRAM - SEDAN ".

1. CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT
   1. Turn ignition switch OFF.
   2. Disconnect combination meter connector and washer level switch connector.
   3. Check continuity between combination meter harness connector M24 terminal 29 and washer level switch harness connector E208 terminal 1.

      29 - 1: Continuity should exist. 

   4. Check continuity between combination meter harness connector M24 terminal 29 and ground.

      29 - Ground: Continuity should not exist. 

      Is the inspection result normal? 

      YES: GO TO 2

      NO: Repair harness or connector.

2. CHECK WASHER LEVEL SWITCH GROUND CIRCUIT

   Check continuity between washer fluid level switch harness connector E208 terminal 2 and ground.

   2 - Ground: Continuity should exist. 

   Is the inspection result normal? 

   YES: Inspection End.

   NO: Repair harness or connector.