Symptom Table

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

If ABS warning lamp, VDC OFF indicator lamp and SLIP indicator lamp turn ON, perform self-diagnosis.

SYMPTOM CHART

Symptom	Check item	Reference
Excessive ABS function operation frequency	Brake force distribution	"DIAGNOSIS PROCEDURE "
	Looseness of front and rear axle
	Wheel sensor and rotor system
Unexpected pedal reaction	Brake pedal stroke	"DIAGNOSIS PROCEDURE "
Unexpected pedal reaction	Make sure the braking force is sufficient when the ABS is not operating.	"DIAGNOSIS PROCEDURE "
The braking distance is long	Check stopping distance when the ABS is not operating.	"DIAGNOSIS PROCEDURE "
ABS function does not operate (Note 1)	ABS actuator and electric unit (control unit)	"DIAGNOSIS PROCEDURE "
Pedal vibration or ABS operation sound occurs (Note 2)	Brake pedal	"DIAGNOSIS PROCEDURE "
Pedal vibration or ABS operation sound occurs (Note 2)	ABS actuator and electric unit (control unit)	"DIAGNOSIS PROCEDURE "
Vehicle jerks during VDC/TCS/ABS control	ABS actuator and electric unit (control unit)	"DIAGNOSIS PROCEDURE "
	TCM
	ECM
NOTE: 1: The ABS does not operate when the speed is 10 km/h (6 MPH) or less. 2: Under the following conditions, ABS is activated and vibration is felt when brake pedal is lightly depressed (just place a foot on it). However, this is normal. When shifting gears When driving on slippery road During cornering at high speed When passing over bumps or grooves [at approximately 50 mm (1.97 in) or more] When pulling away just after starting engine [at approximately 10 km/h (6 MPH) or higher]