Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- SYMPTOM CHECK
Check if the vehicle jerks during VDC/TCS/ABS control.
Is the inspection result normal?
YES: Normal.
NO: GO TO 2
- CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnostic of ABS actuator and electric unit (control unit).
Are self-diagnosis results indicated?
YES: Check corresponding items, make repairs, and perform ABS actuator and electric unit (control unit) self-diagnosis.
NO: GO TO 3
- CHECK CONNECTOR
- Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector and check terminal for deformation, disconnection, looseness, etc.
- Securely connect connector and perform ABS actuator and electric unit (control unit) self-diagnosis.
Are self-diagnosis results indicated?
YES: If poor contact, damage, open or short circuit of connector terminal is found, repair or replace.
NO: GO TO 4
- CHECK ECM AND A/T SELF-DIAGNOSIS RESULTS
Perform ECM and CVT self-diagnosis.
Are self-diagnosis results indicated?
YES: Check the corresponding items.
- ECM: Refer to "CONSULT-III FUNCTION ".
- CVT: Refer to "CONSULT-III FUNCTION (TRANSMISSION) ".
NO: Replace ABS actuator and electric unit (control unit). Refer to "REMOVAL AND INSTALLATION ".