LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2118 (Seats) >> Automatic Drive Positioner >> Trouble Diagnosis >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Symptom Diagnoses / service procedure Refer to
A part of seat system does not operate (both automatically and manually). 1. Sliding motor circuit inspection SLIDING MOTOR CIRCUIT INSPECTION 
2. Reclining motor circuit inspection RECLINING MOTOR CIRCUIT INSPECTION 
3. Front lifter motor circuit inspection FRONT LIFTING MOTOR CIRCUIT INSPECTION 
4. Rear lifter motor circuit inspection REAR LIFTING MOTOR CIRCUIT INSPECTION 
5. If the above systems are normal, replace the driver seat control unit. -
A part of door mirror does not operate (both automatically and manually). 1. Mirror motor LH circuit check MIRROR MOTOR LH CIRCUIT INSPECTION 
2. Mirror motor RH circuit check MIRROR MOTOR RH CIRCUIT INSPECTION 
3. If the above systems are normal, replace the automatic drive positioner control unit. -
Symptom Diagnoses / service procedure Refer to
A part of seat system does not operate (only automatic operation). 1. Sliding sensor circuit inspection SLIDING SENSOR CIRCUIT INSPECTION 
2. Reclining sensor circuit inspection RECLINING SENSOR CIRCUIT INSPECTION 
3. Front lifting sensor circuit inspection FRONT LIFTING SENSOR CIRCUIT INSPECTION 
4. Rear lifting sensor circuit inspection REAR LIFTING SENSOR CIRCUIT INSPECTION 
5. If the above systems are normal, replace the driver seat control unit. -
A part of door mirror system does not operate (only automatic operation). 1. Mirror sensor LH circuit check MIRROR SENSOR LH CIRCUIT INSPECTION 
2. Mirror sensor RH circuit check MIRROR SENSOR RH CIRCUIT INSPECTION 
3. If the above systems are normal, replace the automatic drive positioner control unit. -
All the automatic operations do not operate. 1. CVT device [detention switch (key)] circuit inspection CVT DEVICE [DETENTION SWITCH (KEY)] CIRCUIT INSPECTION 
2. Key switch and ignition knob switch circuit inspection KEY SWITCH AND IGNITION KNOB SWITCH CIRCUIT INSPECTION 
3. UART communication line circuit inspection UART COMMUNICATION LINE CIRCUIT INSPECTION 
4. Tilt sensor circuit inspection TILT SENSOR CIRCUIT INSPECTION 
5. Telescopic sensor circuit inspection TELESCOPIC SENSOR CIRCUIT INSPECTION 
6. If all the above systems are normal, replace the automatic drive positioner control unit. -
A part of seat system does not operate (only manual operation). 1. Sliding switch circuit inspection SLIDING SWITCH LH CIRCUIT INSPECTION 
2. Reclining switch circuit inspection RECLINING SWITCH LH INSPECTION 
3. Front lifting switch circuit inspection FRONT LIFTING SWITCH CIRCUIT INSPECTION 
4. Rear lifting switch circuit inspection REAR LIFTING SWITCH CIRCUIT INSPECTION 
5. If the above systems are normal, replace the driver seat control unit. -
Seat function does not operate (only automatic operation). 1. Sliding sensor circuit inspection SLIDING SENSOR CIRCUIT INSPECTION 
2. Reclining sensor circuit inspection RECLINING SENSOR CIRCUIT INSPECTION 
3. Front lifting sensor circuit inspection FRONT LIFTING SENSOR CIRCUIT INSPECTION 
4. Rear lifting sensor circuit inspection REAR LIFTING SENSOR CIRCUIT INSPECTION 
5. If the above systems are normal, replace the driver seat control unit. -
A part of door mirror does not operate (only manual operation). 1. Door mirror remote control switch (change over switch) circuit inspection DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH) CIRCUIT CHECK 
2. Door mirror remote control switch (mirror switch) switching circuit inspection DOOR MIRROR REMOTE CONTROL SWITCH (MIRROR SWITCH) CIRCUIT CHECK 
3. If the above systems are normal, replace the automatic drive positioner control unit. -
Automatic drive positioner system does not operate (only memory switch operation). 1. Seat memory switch circuit inspection SEAT MEMORY SWITCH CIRCUIT INSPECTION 
2. If the above systems are normal, replace the driver seat control unit. -
Seat memory indicator lamps 1 and 2 do not illuminate. 1. Seat memory indicator lamp circuit inspection SEAT MEMORY INDICATOR LAMP CIRCUIT INSPECTION 
2. If all the above systems are normal, replace the driver seat control unit. -
The Entry/Exiting does not operate when door is opened and closed. (The Entry/Exiting operates with key switch). 1. Front door switch LH circuit inspection FRONT DOOR SWITCH LH CIRCUIT INSPECTION 
2. If all the above systems are normal, replace the BCM. -
Seat system does not operate (only manual operation). 1. Power seat switch ground circuit inspection POWER SEAT SWITCH LH GROUND INSPECTION