Door Mirror Remote Control Switch (Changeover Switch) Circuit Check

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUNCTION

With CONSULT-III

Check operation with "MIR CHNG SW-R, MIR CHNG SW-L" on the DATA MONITOR to make sure pulse changes.

MIR CHNG SW MONITOR ITEM CHART

Monitor item [OPERATION or UNIT]		Contents
MIR CHNG SW-R	"ON/OFF"	ON/OFF status judged from the door mirror remote control switch (switching to RIGHT) signal is displayed.
MIR CHNG SW-L	"ON/OFF"	ON/OFF status judged from the door mirror remote control switch (switching to LEFT) signal is displayed.

Without CONSULT-III

Turn ignition switch to ACC.

Check voltage between automatic drive positioner control unit connector and ground.

AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND GROUND

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M41	2	Ground	Changeover switch RIGHT position	0
	2		Other than above	5
	18		Changeover switch LEFT position	0
	18		Other than above	5

Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Door mirror remote control switch (changeover switch) circuit is OK.

NG: GO TO 2.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH CIRCUIT HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
3. Check continuity between automatic drive positioner control unit connector M41 terminals 2, 18 and door mirror remote control switch connector M7 terminals 2, 3.
  2 - 3: Continuity should exist.
  
  18 - 2: Continuity should exist.
4. Check continuity between automatic drive positioner control unit connector M41 terminals 2,18 and ground.
  2 - Ground: Continuity should not exist.
  
  18 - Ground: Continuity should not exist.
Fig 2: Checking Door Mirror Remote Control Switch Circuit Harness Continuity
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH)

Check continuity between door mirror remote control switch terminals as follows.

DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH)

Terminals		Condition	Continuity
2	13	Changeover switch LEFT position	Yes
2		Other than above	No
3		Changeover switch RIGHT position	Yes
3		Other than above	No

Fig 3: Checking Continuity Between Door Mirror Remote Control Switch Terminal

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check the condition of the harness and the connector.

NG: Replace door mirror remote control switch.