Mirror Motor RH Circuit Inspection

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MIRROR MOTOR RH MECHANISM
Check the following items.

Operation malfunction caused by a foreign object caught in door mirror face edge.

OK or NG

OK: GO TO 2.

NG: Repair the malfunctioning part and check again.

CHECK FUNCTION

With CONSULT-III

Check operation with "MIRROR MOTOR RH" in ACTIVE TEST.

MIRROR MOTOR RH TEST ITEM DESCRIPTION

Test item	Description
MIRROR MOTOR RH	The mirror motor LH is activated by receiving the drive signal.

Without CONSULT-III

GO TO 3.

OK or NG

OK: Mirror motor RH circuit is OK.

NG: GO TO 3.

CHECK MIRROR MOTOR RH HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror RH.
3. Check continuity between automatic drive positioner control unit connector M41 terminals 14,15, 30 and door mirror RH connector D107 terminals 8, 9,10.
  14 - 10: Continuity should exist.
  
  15 - 9: Continuity should exist.
  
  30 - 8: Continuity should exist.
4. Check continuity between automatic drive positioner control unit connector M41 terminals 14, 15, 30 and ground.
  14 - Ground: Continuity should not exist.
  
  15 - Ground: Continuity should not exist.
  
  30 - Ground: Continuity should not exist.
Fig 1: Checking Mirror Motor RH Harness Continuity
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 4.

NG: Repair or replace harness.

CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL

Connect the automatic drive positioner control unit and door mirror RH.
Turn ignition switch to ACC.

Check voltage between door mirror RH connector and ground.

AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D107	8	Ground	When motor is DOWN or RIGHT operation	1.7 - Battery voltage
	8		Other than above	0
	9		When motor is LEFT operation	1.7 - Battery voltage
	9		Other than above	0
	10		When motor is UP operation	1.7 - Battery voltage
	10		Other than above	0

Fig 2: Checking Voltage Between Door Mirror RH Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace door mirror RH. Refer to "DOOR MIRROR ASSEMBLY ".

NG: Replace automatic drive positioner control unit.